Your shopping cart is empty.

Products

Add to cart
$ 2.95

#10 x 1” PPH Screw for Aluminum Recessed Track (10pcs)

Add to cart
$ 17.49

For the serious kayak angler, the RAM Quick Release Track Base is a universal mounting solution for a wide variety of kayak products including RAM fishing rod holders, camera and transducer deployment arms.  Track Dimensional Range:.250" MIN. - .562" MAX. 

Add to cart
$ 15.99

The RAM double ball joiner, consists of a 1" rubber ball on both ends that allow the connection of two 1" socket arms. When measured from ball center to ball center the arm length is 1.75". This mount is ideal if your mount arm is just too short.

Add to cart
$ 8.99

This Ram Mount consists of a 1" diameter rubber ball, connected to a 1/4"-20 X .50" male threaded post. The male thread matches most standard camera and camcorder female threads found on the bottom of the camera.

Add to cart
$ 8.99

This mount is made up of a B size 1" rubber ball molded to a high strength composite base, a rubber friction washer and a stainless steel T-bolt for sliding into virtually any track system. Simply insert or slide the Track Ball into your track and twist the ball clockwise to tighten in place. Twist counterclockwise to loosen or adjust...

Add to cart
$ 11.49

1.5" Ball and Hardware for RAM 5 Spot Mounting Base

Add to cart
$ 21.99

For the serious kayak angler, the RAM Quick Release Track Base is a universal mounting solution for a wide variety of kayak products including RAM fishing rod holders, camera and transducer deployment arms..Track Dimensional Range:.250" MIN. - .562" MAX. 

Add to cart
$ 21.49

The Track Ball Side Track Base consists of a t-bolt, ratchet tooth and groove composition and 1.5” rubber ball. With a turn of the knob you can quickly fasten, adjust or remove the base to your existing track system.

Add to cart
$ 3.95

This is a replacement part for 1.5" Black Webbing (4 ft).  You can cut it into smaller pieces to replace the webbing for the buckles.  Buckles are sold separately.

Add to cart
$ 3.95

1.5" Male and Female buckle set for your Gator Hatch

Add to cart
$ 20.99

The RAM double socket connector allows you to connect two socket arms together and maintain a flexible mount.

Add to cart
$ 11.49

This mount consists of a 1.5" diameter rubber ball, connected to a 1/4"-20 X .625" male threaded post. The male thread matches most standard camera and camcorder female threads found on the bottom of the camera.